Hello
I would appreciate a recommendation (based on experience) on where I could source some good UHF connectors (PL-259s for RG-58 and RG-213). Ideally a balance of quality and value.
I am finding it harder to locate stores (in Perth) that stock them and the connectors that I have found appear to be not of a high quality and a bit temperamental to solder.
Perhaps you look to the East for a supplier. If this is the case, please let me know.
Regards
Peter
UHF Connectors
Moderator: VK6ZMS
-
- Moderator
- Posts: 2993
- Joined: Sat Feb 09, 2008 10:06 am
- Amateur callsign: VK6UFO_VK6RN
- Scanners and Receivers:
Scanners/receivers
Diamond Welz WS1000 wideband handheld
Radioshack Pro 28 handheld
Uniden UBC72XLT handheld
Uniden UBC73XLT handheld
Uniden UBC330CRS desktop
Two-way
Yaesu VX-3R 2m/70cm Ham TRX and wideband RX handheld
Yaesu FT-1802M 2m Ham TRX mobile x 2
Yaesu FT-7800R 2m/70cm Ham TRX and wide band RX mobile
Icom IC-208H 2m/70cm Ham TRX and wide band RX mobile
Icom IC-706MKIIG all-band all-mode Ham TRX mobile
Icom IC-V85 2m VHF Ham TRX handheld
Wouxun KG-UVD1P VHF/UHF wideband Ham TRX handheld
Wouxun KG-679P VHF wideband Ham TRX handheld
Wouxun KG-713 UHF wideband Ham TRX handheld - Location: Just on the border of your waking mind
Re: UHF Connectors
WA CB have them, although personally I think they are overpriced. Some clubs also sell them. We have them at the HARG club meetings. Prestige sell them here and here but I can't comment on the quality.
Rob
OF78WD
Amateur moderator
.
→Arguing with a fool proves there are two
OF78WD
Amateur moderator
.
→Arguing with a fool proves there are two
-
- Site Admin
- Posts: 2610
- Joined: Thu Feb 24, 2005 10:33 pm
- Amateur callsign: VK6HGR
- Scanners and Receivers: Various Yaesu, Kenwood, Tait, Simoco and Philips'
- Location: Perth, Western Australia
- Contact:
Re: UHF Connectors
Agreed.WPXZBP wrote:Check out Jaycar and Altronics. I've had no problems with theirs.
Just be careful with RG58 connectors. The nice folks at the stores aren't always careful to make sure the 75 Ohm connectors for RG59 security camera work don't end up in the RG58 bin
Gavin Rogers; VK6HGR
http://vk6hgr.ampr.org/
WARSUG forum administrator
Site and stream donations: https://www.paypal.me/vk6hgr
http://vk6hgr.ampr.org/
WARSUG forum administrator
Site and stream donations: https://www.paypal.me/vk6hgr
Re: UHF Connectors
I have given up on sourcing connectors from local shops, and now get them on eBay from China.
Most of the time you can get them for <$3 each with free postage, and they take about a week to arrive.
Most of the time you can get them for <$3 each with free postage, and they take about a week to arrive.
Re: UHF Connectors
In recent times I've got good quality connectors for RG-213 from Mini-Kits in South Australia (www.minikits.com.au).