Just my findings this morning, CH 180 Dumas House still isn't active yet it seems and neither is Scarb's
51 on the old system (Claremont I believe) only starts kicking in at road level from about Reid Hwy for us Northerners.
I also made the brainwave of having the common working channels in the scanner with Delay turned *off* on each channel. This way if it hits a channel that is broken it will skip to the next until one is clear [-o<
New VHF channels
Moderator: bogged
Re: New VHF channels
"VKI, NJ050 will you be attending the job?"
"Negative VKI, my desk is bolted to the floor".
WARSUG General Scanning Moderator
"Negative VKI, my desk is bolted to the floor".
WARSUG General Scanning Moderator
-
- Site Admin
- Posts: 2610
- Joined: Thu Feb 24, 2005 10:33 pm
- Amateur callsign: VK6HGR
- Scanners and Receivers: Various Yaesu, Kenwood, Tait, Simoco and Philips'
- Location: Perth, Western Australia
- Contact:
Re: New VHF channels
Yes, It's the next best thing to having a receiver that supports voting. This is why I (still) use Philips FM92s. As soon as one channel has a signal, it automatically scans the rest of the channels in the group (i.e. 51,53,55,57 etc) and finds the strongest.yorky wrote: I also made the brainwave of having the common working channels in the scanner with Delay turned *off* on each channel. This way if it hits a channel that is broken it will skip to the next until one is clear [-o<
Gavin Rogers; VK6HGR
http://vk6hgr.ampr.org/
WARSUG forum administrator
Site and stream donations: https://www.paypal.me/vk6hgr
http://vk6hgr.ampr.org/
WARSUG forum administrator
Site and stream donations: https://www.paypal.me/vk6hgr
Re: New VHF channels
Just spotted these posts. I used to travel alot between Claremont and Kingsley area. 51 has always been quite weak, and I used to have a lot of trouble with it, I think it was OK to about Scarbs, then pretty useless. The coast up from there is difficult, as you can't quite get a good signal from Red Hill, though I used to survive on that. Not sure how the new freqs have changed this. I seem to recall a comms tech telling me it had something to do with all the limestone in the area?? Very vague memory. Handheld scanner even connected to a vehicle mounted whip was very ordinary up that way, as with alot of Perth. I managed to get a good old VHF radio programmed to receive that did a very good job.
Photos:: liveitseeit.com
Re: New VHF channels
Yep up this way along the cost Redhill 163.250 is pretty useless until you head east then its clear.
The best I can get down the coast and north is Canning Mills 164.000 or the old 78.100 or Wannaroo 70.075 once north past ~Reid Hwy then further up its crystal clear.
The best I can get down the coast and north is Canning Mills 164.000 or the old 78.100 or Wannaroo 70.075 once north past ~Reid Hwy then further up its crystal clear.
"VKI, NJ050 will you be attending the job?"
"Negative VKI, my desk is bolted to the floor".
WARSUG General Scanning Moderator
"Negative VKI, my desk is bolted to the floor".
WARSUG General Scanning Moderator
-
- Moderator
- Posts: 3746
- Joined: Sun Feb 18, 2007 5:41 pm
- Amateur callsign: VK6FWDH
- Scanners and Receivers: UBC93XLT
- Location: Helena Valley
- Contact:
Re: New VHF channels
Yeah radio waves don't travel through limestone very well but thats through it, over the top should be fine.
Stirling SES
Team Leader (Stirling 53)
Vertical Rescue Team Member
K9 7 Support
VK6FWDH
ex-Darlington FB
WARSUG Demi-God I mean Mod
If stupidity got me into this mess, why can't it get me out.
Team Leader (Stirling 53)
Vertical Rescue Team Member
K9 7 Support
VK6FWDH
ex-Darlington FB
WARSUG Demi-God I mean Mod
If stupidity got me into this mess, why can't it get me out.
-
- Posts: 19
- Joined: Mon Dec 21, 2009 11:32 pm
- Scanners and Receivers: Uniden UBCT8,Uniden UBC126AT,Whistler TRX-1,Whistler TRX-2,AOR AR-DV1.Plus Motorola, Kenwood, Tait, Vertex, Icom, Simoco,Philips.
- Location: Mandurah
Re: New VHF channels
linked active vhf hi freq's
164.000MHz canning mills ch141
164.275MHz hackets gully ch207
164.3375MHz jarradale ch220
163.250MHz red hill ch306
164.8875MHz seabird ch317
164.3125MHz huntley ch217
164.000MHz canning mills ch141
164.275MHz hackets gully ch207
164.3375MHz jarradale ch220
163.250MHz red hill ch306
164.8875MHz seabird ch317
164.3125MHz huntley ch217
-
- Posts: 19
- Joined: Mon Dec 21, 2009 11:32 pm
- Scanners and Receivers: Uniden UBCT8,Uniden UBC126AT,Whistler TRX-1,Whistler TRX-2,AOR AR-DV1.Plus Motorola, Kenwood, Tait, Vertex, Icom, Simoco,Philips.
- Location: Mandurah
Re: New VHF channels
hi i was looking on the acma web site and found 2 vhf hi FESA freq's that are not in the WAERN channel pdf
the freq's are 163.675MHz & 164.6125MHz at the canning mills site.
any ideas?.
the freq's are 163.675MHz & 164.6125MHz at the canning mills site.
any ideas?.
Re: New VHF channels
Not sure on those Canning Mills ones but what I did just find interesting is that the Scarborough 163.325 is actually on ACMA under FESA SES (as well as 163.05 Dumas House).
"VKI, NJ050 will you be attending the job?"
"Negative VKI, my desk is bolted to the floor".
WARSUG General Scanning Moderator
"Negative VKI, my desk is bolted to the floor".
WARSUG General Scanning Moderator
Re: New VHF channels
Those repeaters are used by SES
MELVILLE 80
The worst in nature brings out the best in us! STATE EMERGENCY SERVICE WE SERVE
The worst in nature brings out the best in us! STATE EMERGENCY SERVICE WE SERVE
-
- Moderator
- Posts: 3746
- Joined: Sun Feb 18, 2007 5:41 pm
- Amateur callsign: VK6FWDH
- Scanners and Receivers: UBC93XLT
- Location: Helena Valley
- Contact:
Re: New VHF channels
Treeny SES repeaters are all UHF, those frequencies are VHF. If anything those may be control links for the respective frequencies depending on how the repeaters are configured.
Stirling SES
Team Leader (Stirling 53)
Vertical Rescue Team Member
K9 7 Support
VK6FWDH
ex-Darlington FB
WARSUG Demi-God I mean Mod
If stupidity got me into this mess, why can't it get me out.
Team Leader (Stirling 53)
Vertical Rescue Team Member
K9 7 Support
VK6FWDH
ex-Darlington FB
WARSUG Demi-God I mean Mod
If stupidity got me into this mess, why can't it get me out.
Re: New VHF channels
if they are not 6AR/6IP channels, they could be BFB Repeater Channels for Roleystone, Gossnels. or just channels the City of Armadale, or Gossnels uses. i know that that is where there current channels are based.radioman061 wrote:hi i was looking on the acma web site and found 2 vhf hi FESA freq's that are not in the WAERN channel pdf
the freq's are 163.675MHz & 164.6125MHz at the canning mills site.
any ideas?.
----BUDDAH VFRS----
-
- Posts: 18
- Joined: Wed Feb 25, 2009 8:59 am
Re: New VHF channels
radioman061 wrote:hi i was looking on the acma web site and found 2 vhf hi FESA freq's that are not in the WAERN channel pdf
the freq's are 163.675MHz & 164.6125MHz at the canning mills site.
any ideas?.
Since you have found this, if you look around some more you will notice there are 16 or so channels not listed in the WAERN list on this site that are located around the state. The locations may lead to possible questions or thoughts.... (and no, I am not getting into a discussion on this)
How much of the plan is public knowledge I am not sure, those of you in brigades, try asking through correct channels or the association for the WAERN presentation which gives a good overview of the current and future plan.
-
- Site Admin
- Posts: 2610
- Joined: Thu Feb 24, 2005 10:33 pm
- Amateur callsign: VK6HGR
- Scanners and Receivers: Various Yaesu, Kenwood, Tait, Simoco and Philips'
- Location: Perth, Western Australia
- Contact:
Re: New VHF channels
Cataloguing these extra channels sounds like work for someone with some free time and an all-seasons pass to the ACMA databasefire&rescuetraining wrote: Since you have found this, if you look around some more you will notice there are 16 or so channels not listed in the WAERN list on this site that are located around the state.
I'm puzzled why WAERN channels seem to be so secret, though...
Gavin Rogers; VK6HGR
http://vk6hgr.ampr.org/
WARSUG forum administrator
Site and stream donations: https://www.paypal.me/vk6hgr
http://vk6hgr.ampr.org/
WARSUG forum administrator
Site and stream donations: https://www.paypal.me/vk6hgr
Re: New VHF channels
Sorry to dig up an old thread, but it is linked in the FESA one stop shop thread..
What would be the best WAERN frequency for a handheld scanner in the CBD?
I have found 78.050 which is Claremont but I would prefer one of the WAERN VHF-HI channels instead of the midband...
The one on top of Dumas house in West Perth appears to be licensed in the ACMA database but it is not active. I monitored it for a few days and heard nothing.
Thanks
What would be the best WAERN frequency for a handheld scanner in the CBD?
I have found 78.050 which is Claremont but I would prefer one of the WAERN VHF-HI channels instead of the midband...
The one on top of Dumas house in West Perth appears to be licensed in the ACMA database but it is not active. I monitored it for a few days and heard nothing.
Thanks
-
- Moderator
- Posts: 1628
- Joined: Fri Jan 13, 2006 1:15 am
- Location: Greenmount
Re: New VHF channels
163.250 seems to be a popular WAERN frequency choice for monitoring FESA (6AR/6IP), although it seems to be inactive at the moment for some reason. Another suggestion has been 164.000.
WARSUG Moderator - Media Section
VBFB Member
No onion, no garlic, no chilli, no pepper... NO POINT!!
VBFB Member
No onion, no garlic, no chilli, no pepper... NO POINT!!