I was reading the reviews on the Unadilla dipole antenna http://www.unadilla.com/?p=36, and found this comment on how this guy (VE2DC) blew up those 40 meters traps ... How could he blow up traps ? Aren't traps just a piece of wire wound around a plastic tubes ? http://www.eham.net/reviews/detail/963?page=2
After blowing up a few pairs of their 40M traps... I would caution against trying to use them with high power even they are supposedly rated for it. Interestingly, a pair of 75M traps I have used for years from the same manufacturer have been trouble free.
Nosferatu wrote:I was reading the reviews on the Unadilla dipole antenna http://www.unadilla.com/?p=36, and found this comment on how this guy (VE2DC) blew up those 40 meters traps ... How could he blow up traps ? Aren't traps just a piece of wire wound around a plastic tubes ? http://www.eham.net/reviews/detail/963?page=2
They could short out if the wire diameter isn't large enough... I think in VE land they can use 1kW of power.
Two-way Yaesu VX-3R 2m/70cm Ham TRX and wideband RX handheld Yaesu FT-1802M 2m Ham TRX mobile x 2 Yaesu FT-7800R 2m/70cm Ham TRX and wide band RX mobile Icom IC-208H 2m/70cm Ham TRX and wide band RX mobile Icom IC-706MKIIG all-band all-mode Ham TRX mobile Icom IC-V85 2m VHF Ham TRX handheld Wouxun KG-UVD1P VHF/UHF wideband Ham TRX handheld Wouxun KG-679P VHF wideband Ham TRX handheld Wouxun KG-713 UHF wideband Ham TRX handheld
Nosferatu wrote:I was reading the reviews on the Unadilla dipole antenna http://www.unadilla.com/?p=36, and found this comment on how this guy (VE2DC) blew up those 40 meters traps ... How could he blow up traps ? Aren't traps just a piece of wire wound around a plastic tubes ? http://www.eham.net/reviews/detail/963?page=2
They could short out if the wire diameter isn't large enough... I think in VE land they can use 1kW of power.
Yes indeedy, they could overheat and short or go open circuit - just like any electrical conductor with too much current. They may also have capacitors in them and the rated votage was exceeded causing arcing across the plates.
It's a bit of a worry when the rated power wasn't exceeded though (allegedly..)
Rob
OF78WD Amateur moderator . →Arguing with a fool proves there are two