Amateur information beacon VK6RIB
Moderator: VK6ZMS
-
- 150+ posts
- Posts: 244
- Joined: Thu Oct 27, 2011 3:39 pm
- Scanners and Receivers: Uniden 536HP DMR,NXDN Uniden USDS100 DMR,NXDN Codan NGT
Re: Amateur information beacon VK6RIB
Im getting something on that frequency.Signal is about 2 out of 10 but strength is about 5 out of 10 and readable.Im in Balcatta Perth.Hope it helps.
-
- Site Admin
- Posts: 3022
- Joined: Thu Feb 24, 2005 10:42 pm
- Amateur callsign: VK6DB
- Location: Perth
- Contact:
Re: Amateur information beacon VK6RIB
Awesome - hopefully you're getting a recording of people's voices and stuff. Are you using a handheld scanner indoors, or an antenna on the roof of your house?allycat wrote:Im getting something on that frequency.Signal is about 2 out of 10 but strength is about 5 out of 10 and readable.Im in Balcatta Perth.Hope it helps.
Doug Bell (Zebedee) VK6DB
WARSUG Forum Administrator.
It is very dark.
You are likely to be eaten by a grue.
WARSUG Forum Administrator.
It is very dark.
You are likely to be eaten by a grue.
-
- Moderator
- Posts: 2993
- Joined: Sat Feb 09, 2008 10:06 am
- Amateur callsign: VK6UFO_VK6RN
- Scanners and Receivers:
Scanners/receivers
Diamond Welz WS1000 wideband handheld
Radioshack Pro 28 handheld
Uniden UBC72XLT handheld
Uniden UBC73XLT handheld
Uniden UBC330CRS desktop
Two-way
Yaesu VX-3R 2m/70cm Ham TRX and wideband RX handheld
Yaesu FT-1802M 2m Ham TRX mobile x 2
Yaesu FT-7800R 2m/70cm Ham TRX and wide band RX mobile
Icom IC-208H 2m/70cm Ham TRX and wide band RX mobile
Icom IC-706MKIIG all-band all-mode Ham TRX mobile
Icom IC-V85 2m VHF Ham TRX handheld
Wouxun KG-UVD1P VHF/UHF wideband Ham TRX handheld
Wouxun KG-679P VHF wideband Ham TRX handheld
Wouxun KG-713 UHF wideband Ham TRX handheld - Location: Just on the border of your waking mind
Re: Amateur information beacon VK6RIB
S5 with my FT7800 and high-gain antenna up high in Ballajura.
Rob
OF78WD
Amateur moderator
.
→Arguing with a fool proves there are two
OF78WD
Amateur moderator
.
→Arguing with a fool proves there are two
-
- 150+ posts
- Posts: 244
- Joined: Thu Oct 27, 2011 3:39 pm
- Scanners and Receivers: Uniden 536HP DMR,NXDN Uniden USDS100 DMR,NXDN Codan NGT
Re: Amateur information beacon VK6RIB
Awesome - hopefully you're getting a recording of people's voices and stuff. Are you using a handheld scanner indoors, or an antenna on the roof of your house?[/quote]
Indoor Uniden 396t scanner with a discone ontop 2 story building.
Indoor Uniden 396t scanner with a discone ontop 2 story building.
Last edited by allycat on Mon Oct 08, 2012 8:03 am, edited 1 time in total.
-
- Site Admin
- Posts: 2610
- Joined: Thu Feb 24, 2005 10:33 pm
- Amateur callsign: VK6HGR
- Scanners and Receivers: Various Yaesu, Kenwood, Tait, Simoco and Philips'
- Location: Perth, Western Australia
- Contact:
Re: Amateur information beacon VK6RIB
Weak signal at my QTH in Beechboro but that site has always been difficult here. (I assume its using the old VK6BBS antenna?)
We need VK6RIB mark II for the northern suburbs
We need VK6RIB mark II for the northern suburbs
Gavin Rogers; VK6HGR
http://vk6hgr.ampr.org/
WARSUG forum administrator
Site and stream donations: https://www.paypal.me/vk6hgr
http://vk6hgr.ampr.org/
WARSUG forum administrator
Site and stream donations: https://www.paypal.me/vk6hgr
Re: Amateur information beacon VK6RIB
It has its own 3dBi antenna. BBS is still on air.
Amateur Radio Moderator
-
- Site Admin
- Posts: 3022
- Joined: Thu Feb 24, 2005 10:42 pm
- Amateur callsign: VK6DB
- Location: Perth
- Contact:
Re: Amateur information beacon VK6RIB
Hey it's hard enough getting one site up and running, never mind two!vk6hgr wrote:Weak signal at my QTH in Beechboro but that site has always been difficult here. (I assume its using the old VK6BBS antenna?)
We need VK6RIB mark II for the northern suburbs
Martin's right, it's running off a basic 3dBi omni, mounted on the VHF Group's mast up at Wireless Hill. (It's actually upside down from the crow's nest so as not to get in the way of any of the beams that are mounted further up.) Output is still only around 10W.
If you know where to look, it's just visible on this picture (taken from the VI6VIP special event callsign entry on qrz.com)
Since one of the ideas for the beacon is to provide information to visitors, I've been playing around with my handheld this morning seeing what I can reach and from where. From Mirrabooka, standing out in the shopping centre car park, it's around S2-S3... readable but weak. Driving down the freeway it cuts in and out (this is a handheld inside a vehicle, no special antennas or anything). It's readable but weak in at the western side of the CBD. If you stand in just the right spot near the new Perth Arena you can get a readable signal. Move 5 metres sideways and it disappears...
Doug Bell (Zebedee) VK6DB
WARSUG Forum Administrator.
It is very dark.
You are likely to be eaten by a grue.
WARSUG Forum Administrator.
It is very dark.
You are likely to be eaten by a grue.
Re: Amateur information beacon VK6RIB
It was audible but scratchy in the dips today during a drive along Ocean Reef Rd, heading east from the marina to Wanneroo Rd.
Amateur Radio Moderator
Re: Amateur information beacon VK6RIB
Wasn't reachable for me driving through Welshpool / Queens Park area, further north I started picking it up more.
In car scanner with 4.5dB external antenna.
In car scanner with 4.5dB external antenna.
"VKI, NJ050 will you be attending the job?"
"Negative VKI, my desk is bolted to the floor".
WARSUG General Scanning Moderator
"Negative VKI, my desk is bolted to the floor".
WARSUG General Scanning Moderator
-
- Posts: 6
- Joined: Mon Jun 07, 2010 11:47 pm
- Amateur callsign: vk6zse
- Scanners and Receivers: I use my AR trx
- vx170 (Rx covers 137 - 174 Mhz)
Re: Amateur information beacon VK6RIB
When driving back from Wireless Hill on Wednesday 10th Oct, with yaesu vx-170 in the car I could hear the VK6RIB beacon most of the way home (via the freeway) somtimes it dropped out for a second here and there but it was mostly readable on the trip home to Edgewater
I had backed off the mute to level 0 on the VX-170 before I left wireless hill, so this had helped.
VK6RIB signal into Joondalup is usually S1 to S3 depending where you are, in the lakeside shops there is no coverage what so ever, but this is to be expected as all repeaters (appart from VK6RNC 2m and VK6RNA on 438.725 / 433.725 ) are not accessable there.
The VK6BBS packet system is not being affected by vk6rib transmissions where the antenna is located at this time, if the vk6rib antenna was to be shifted there may be some problems unless some filtering was done to vk6bbs and the tx of vk6rib.
Cheers Eddie
VK6YA / VK6ZSE
I had backed off the mute to level 0 on the VX-170 before I left wireless hill, so this had helped.
VK6RIB signal into Joondalup is usually S1 to S3 depending where you are, in the lakeside shops there is no coverage what so ever, but this is to be expected as all repeaters (appart from VK6RNC 2m and VK6RNA on 438.725 / 433.725 ) are not accessable there.
The VK6BBS packet system is not being affected by vk6rib transmissions where the antenna is located at this time, if the vk6rib antenna was to be shifted there may be some problems unless some filtering was done to vk6bbs and the tx of vk6rib.
Cheers Eddie
VK6YA / VK6ZSE
Re: Amateur information beacon VK6RIB
For those who have not seen it, and are interested, here is a bad phone camera image taken yesterday of VK6BBS on the left and VK6RIB in the rack on the right.
Phil VK6ADF
Phil VK6ADF