Transperth A - SETS

Rail, Bus and Ferry services

Moderator: Froggles

Post Reply
written_ficton
WARSUG top poster
WARSUG top poster
Posts: 2716
Joined: Mon Mar 03, 2008 9:08 pm

Transperth A - SETS

Post by written_ficton »

Can someone enlighten me when the first A-SET [& possible number] went into service? Just wondering while travelling on them this morning.
I've closed the door!
Geoff
Posts: 49
Joined: Sun Mar 21, 2010 10:44 am

Re: Transperth A - SETS

Post by Geoff »

Hi WF,

The following quotes have been taken from Wikipedia.

A-Series: Set numbers 01 - 48
http://en.wikipedia.org/wiki/Transperth_A-series_train wrote:The Transperth A-series trains are a class of electric multiple unit operated by Transperth Trains in Perth, Western Australia. When introduced in 1992 the A-series trains became the first electric passenger trains to operate in Western Australia and, until 2004, were the only type of train in use on the Perth suburban rail network.
B-Series: Set numbers 49 - 94 (at the time of writing Set 94 is the latest I have seen in use)
http://en.wikipedia.org/wiki/Transperth_B-series_train wrote:The new B-series was introduced on 4 October 2004 as part of the New MetroRail project. The trains were bought to service the Joondalup Line and Mandurah Line at a cost of A$ 8 999 999 each (≈$9 Million), and are stored and cleaned primarily at the Nowergup railway depot.
Take a look at the general Transperth Trains page for further information.



Geoff
written_ficton
WARSUG top poster
WARSUG top poster
Posts: 2716
Joined: Mon Mar 03, 2008 9:08 pm

Re: Transperth A - SETS

Post by written_ficton »

Geoff wrote:Hi WF,

The following quotes have been taken from Wikipedia.

A-Series: Set numbers 01 - 48
http://en.wikipedia.org/wiki/Transperth_A-series_train wrote:The Transperth A-series trains are a class of electric multiple unit operated by Transperth Trains in Perth, Western Australia. When introduced in 1992 the A-series trains became the first electric passenger trains to operate in Western Australia and, until 2004, were the only type of train in use on the Perth suburban rail network.

Hey thanks for that, how do you know the 'SETS' as i.e number 343 doesn't fit into 01 - 48
I've closed the door!
LighteningCrashes
150+ posts
150+ posts
Posts: 248
Joined: Sat Feb 27, 2010 1:43 pm
Scanners and Receivers: Tait2020

Re: Transperth A - SETS

Post by LighteningCrashes »

Prob set 43 as one car on the a set will be 343 and the other car will be 243. Similarly for b sets
written_ficton
WARSUG top poster
WARSUG top poster
Posts: 2716
Joined: Mon Mar 03, 2008 9:08 pm

Re: Transperth A - SETS

Post by written_ficton »

LighteningCrashes wrote:Prob set 43 as one car on the a set will be 343 and the other car will be 243. Similarly for b sets
I see, thank you very much
I've closed the door!
Geoff
Posts: 49
Joined: Sun Mar 21, 2010 10:44 am

Re: Transperth A - SETS

Post by Geoff »

The set number is comprised of the last couple of digits from the three digit number that's located on the front, centre, or rear of the train, both internally and externally. In your example of 348 the Set Number is 48.


In the case of the A-Series train (comprised of 2 cars) the first digit denotes the following:
2xx - Front (Known as the 'A' End)
3xx - Rear (B End)

For the B-Series (comprised of 3 cars) it is the following:
4xx - Front (A End)
6xx - Centre
5xx - Rear (B End)


On each car that makes up the set, there is also a three letter code before the three digit number. These are located at the end of each car on the outside, just below the level of the platform.

A-Series:
AEA 2xx - A End
AEB 3xx - B End

B-Series:
BEA 4xx - A End
BET 6xx - Centre
BEB 5xx - B End



Geoff
auntys_eyes
Moderator
Moderator
Posts: 1628
Joined: Fri Jan 13, 2006 1:15 am
Location: Greenmount

Re: Transperth A - SETS

Post by auntys_eyes »

Great info there Geoff, thanks for that.
WARSUG Moderator - Media Section

VBFB Member

No onion, no garlic, no chilli, no pepper... NO POINT!!
written_ficton
WARSUG top poster
WARSUG top poster
Posts: 2716
Joined: Mon Mar 03, 2008 9:08 pm

Re: Transperth A - SETS

Post by written_ficton »

Brilliant stuff Geoff, thank you! I managed to score a lift on 201 yesterday...
I've closed the door!
6stbase
Posts: 48
Joined: Mon Mar 10, 2008 1:01 pm
Scanners and Receivers: Uniden USDS100
Location: Loitering

Re: Transperth A - SETS

Post by 6stbase »

AEA = (A) Series (E)lectric (A) End

AEB = (A) Series (E)lectric (B) End

BEA = (B) Series (Electric) (A) End

BET = (B) Series (Electric) (T)railer Car

BEB = (B) Series (Electric) (B) End
6ST Base is clear, is there a mobile calling on this channel?
Post Reply