Page 2 of 2
Re: Introducing the Uniden UBC93XLT Scanner
Posted: Mon Jan 31, 2011 10:18 pm
by spartacus
May I just add that I realized at the Skyshow this year that this radio does not do the FM radio broadcast range - 88MHz till 108MHz.
Re: Introducing the Uniden UBC93XLT Scanner
Posted: Sat May 12, 2012 10:05 am
by Sloand
I have a problem guys, hoping someone can assist me in recovering my 93xlt...
It was working fine and I was getting heaps of signal breaking in through the channels I was scanning, so I started trying to lockout channels....
Bad mistake, next time I'll wear my glasses so I can what buttons I'm hitting.
Scanner turns on and off fine, beeps on, beeps off. Other than that, no sound, no signals located.
I reset with the 2 -9 - Hold - Power for 3 seconds, "clear" appeared, beeped and turned on. All preprogrammed (by me) gone, as warned.
Still the same, squelch wide open, volume up, no hiss, programmed a UHF CD frequency, turned UHF CB transceiver on to same, transmitted, scanner ignored it.
HELP!!! What have I done? What can I do to restore it?
Chris
Re: Introducing the Uniden UBC93XLT Scanner
Posted: Sat May 12, 2012 2:34 pm
by colin
Dumb question, but have you checked your antenna?
Re: Introducing the Uniden UBC93XLT Scanner
Posted: Sun May 13, 2012 8:41 am
by Sloand
colin wrote:Dumb question, but have you checked your antenna?
Yup.
But now it's weird. One for the memory banks, the human ones.
I left it on scanning bank 6 and after a couple of hours, received a signal. Oh Joy! It's working again.
Weird. Coincidentally the rechargeable batteries went low, it started bipping the warning.
Another set of freshly charged batteries in, reprogramming and it's fine.
Weird. I'm wondering if one of the batteries is bad or one was charged the other not. I may be on the wrong tram but it's all I can figure.
Thanks for your reply.
Chris
btw, I'm in Melbourne but this forum was the only site I could find that mentioned this critter.
Re: Introducing the Uniden UBC93XLT Scanner
Posted: Thu Nov 18, 2021 6:49 pm
by henkilook
How do I reset my Uniden scanner?
Re: Introducing the Uniden UBC93XLT Scanner
Posted: Fri Nov 19, 2021 9:03 am
by JhG123
henkilook wrote: ↑Thu Nov 18, 2021 6:49 pm
How do I reset my Uniden scanner?
Which model? If it's the 93XLT, power off the scanner and hold "2", "9" and "HOLD" while you power it on. That should reset it.
Re: Introducing the Uniden UBC93XLT Scanner
Posted: Thu Mar 17, 2022 4:18 am
by reena 20
I still use my Uniden UBC93XLT Scanner. I must say about it, old is Gold.
This phen24 review
Re: Introducing the Uniden UBC93XLT Scanner
Posted: Sat Mar 26, 2022 10:18 am
by rustynswrail
reena 20 wrote: ↑Thu Mar 17, 2022 4:18 am
I still use my Uniden UBC93XLT Scanner. I must say about it, old is Gold.
Nothing wrong with being old!
R