Hi, i have just bought myself an icom ic400pro and setting it up as a home base. i was wondering since they can be programmed, where could i get a hold of the cable and software, and if so, does anyone have any idea about how much it would cost me. its a great radio, but would be even better if i could disable or enable certain features. Any help on this matter would be greatly appreciated.
Thanks,
Brock
icom ic400pro software and cable
-
- Site Admin
- Posts: 2610
- Joined: Thu Feb 24, 2005 10:33 pm
- Amateur callsign: VK6HGR
- Scanners and Receivers: Various Yaesu, Kenwood, Tait, Simoco and Philips'
- Location: Perth, Western Australia
- Contact:
Re: icom ic400pro software and cable
Yes they can be programmed. Cables can be made yourself with a bit of soldering or can be bought from Ebay. This Yahoogroup has the software and more info:
http://groups.yahoo.com/group/ic400pro/
http://groups.yahoo.com/group/ic400pro/
Gavin Rogers; VK6HGR
http://vk6hgr.ampr.org/
WARSUG forum administrator
Site and stream donations: https://www.paypal.me/vk6hgr
http://vk6hgr.ampr.org/
WARSUG forum administrator
Site and stream donations: https://www.paypal.me/vk6hgr
Re: icom ic400pro software and cable
Hope you get it all sussed mate. vk6hgr has given you the exact advice I would have Good luck!Brock wrote:Hi, i have just bought myself an icom ic400pro and setting it up as a home base. i was wondering since they can be programmed, where could i get a hold of the cable and software, and if so, does anyone have any idea about how much it would cost me. its a great radio, but would be even better if i could disable or enable certain features. Any help on this matter would be greatly appreciated.
Thanks,
Brock
[PRC] Perth Radio Club. 495