When I check the voltage of the NiMH cells in my UBC73XLT after a few hours of charging, they read around 1.45V or a bit higher. That seems rather too much and I wonder if the inbuilt charger is intelligent. I sent Uniden an email about this but no response.
I'm considering having a spare set of cells and using an external charger. Is that worthwhile?
Does Uniden UBC73XLT overcharge NiMH cells?
Moderator: Always RX
Re: Does Uniden UBC73XLT overcharge NiMH cells?
Sounds about right. Remember 1.2V is the lowest they should go before conking out, and normal alkaline cells start around 1.5/1.55V.
However With my portable I use an external charger for piece of mind with a spare set of cells on standby so yes its worthwhile.
However With my portable I use an external charger for piece of mind with a spare set of cells on standby so yes its worthwhile.
"VKI, NJ050 will you be attending the job?"
"Negative VKI, my desk is bolted to the floor".
WARSUG General Scanning Moderator
"Negative VKI, my desk is bolted to the floor".
WARSUG General Scanning Moderator
Re: Does Uniden UBC73XLT overcharge NiMH cells?
Thanks Yorky, I think I will get the extra cells because the ones being charged internally also got rather too hot. I know some chargers rely on a temperature rise rather than a Delta-V jump, but that has always seemed a bit primitive.
-
- Moderator
- Posts: 2993
- Joined: Sat Feb 09, 2008 10:06 am
- Amateur callsign: VK6UFO_VK6RN
- Scanners and Receivers:
Scanners/receivers
Diamond Welz WS1000 wideband handheld
Radioshack Pro 28 handheld
Uniden UBC72XLT handheld
Uniden UBC73XLT handheld
Uniden UBC330CRS desktop
Two-way
Yaesu VX-3R 2m/70cm Ham TRX and wideband RX handheld
Yaesu FT-1802M 2m Ham TRX mobile x 2
Yaesu FT-7800R 2m/70cm Ham TRX and wide band RX mobile
Icom IC-208H 2m/70cm Ham TRX and wide band RX mobile
Icom IC-706MKIIG all-band all-mode Ham TRX mobile
Icom IC-V85 2m VHF Ham TRX handheld
Wouxun KG-UVD1P VHF/UHF wideband Ham TRX handheld
Wouxun KG-679P VHF wideband Ham TRX handheld
Wouxun KG-713 UHF wideband Ham TRX handheld - Location: Just on the border of your waking mind
Re: Does Uniden UBC73XLT overcharge NiMH cells?
Yes, 1.2V is the nominal voltage for NiCd and Ni-MH. 1.4-1.5 is a good charge
Rob
OF78WD
Amateur moderator
.
→Arguing with a fool proves there are two
OF78WD
Amateur moderator
.
→Arguing with a fool proves there are two
-
- Posts: 110
- Joined: Mon Nov 21, 2005 10:22 pm
- Scanners and Receivers: AOR 8200 MKIII
- Location: Jandakot
Re: Does Uniden UBC73XLT overcharge NiMH cells?
All this below relates just to those cells in NI-CAD or NI-MH construction.
All secondary (rechargeable)cells like AAA, AA, C and D are ~1.2V nominal.
Primary (non-rechargeable) cells are 1.5 nominal.
Secondary cells should not be charged to more than 1.25V
Secondary cells should not be discharged to lower than 1.05V
Secondary cells should never get much hotter than the ambient temp. If they do they are being over charged.
Ni-MH are exothermic so they will get warm even at C/10.
So to answer the OP question, I do not think the 73XLT has a regulated charger.
My AOR8300 doesn't regulate charging either
All secondary (rechargeable)cells like AAA, AA, C and D are ~1.2V nominal.
Primary (non-rechargeable) cells are 1.5 nominal.
Secondary cells should not be charged to more than 1.25V
Secondary cells should not be discharged to lower than 1.05V
Secondary cells should never get much hotter than the ambient temp. If they do they are being over charged.
Ni-MH are exothermic so they will get warm even at C/10.
So to answer the OP question, I do not think the 73XLT has a regulated charger.
My AOR8300 doesn't regulate charging either
End of Line
-
- Moderator
- Posts: 2993
- Joined: Sat Feb 09, 2008 10:06 am
- Amateur callsign: VK6UFO_VK6RN
- Scanners and Receivers:
Scanners/receivers
Diamond Welz WS1000 wideband handheld
Radioshack Pro 28 handheld
Uniden UBC72XLT handheld
Uniden UBC73XLT handheld
Uniden UBC330CRS desktop
Two-way
Yaesu VX-3R 2m/70cm Ham TRX and wideband RX handheld
Yaesu FT-1802M 2m Ham TRX mobile x 2
Yaesu FT-7800R 2m/70cm Ham TRX and wide band RX mobile
Icom IC-208H 2m/70cm Ham TRX and wide band RX mobile
Icom IC-706MKIIG all-band all-mode Ham TRX mobile
Icom IC-V85 2m VHF Ham TRX handheld
Wouxun KG-UVD1P VHF/UHF wideband Ham TRX handheld
Wouxun KG-679P VHF wideband Ham TRX handheld
Wouxun KG-713 UHF wideband Ham TRX handheld - Location: Just on the border of your waking mind
Re: Does Uniden UBC73XLT overcharge NiMH cells?
Wikipedia wrote:Charging method
A NiCd battery requires a charger with a slightly different voltage charge level than a lead-acid battery, especially if the NiCd has 11 or 12 cells. In addition, the charger requires a more intelligent charge termination method if a fast charger is used. Often NiCd battery packs have a thermal cut-off inside that feeds back to the charger telling it to stop the charging once the battery has heated up and/or a voltage peaking sensing circuit. At room temperature during normal charge conditions the cell voltage increases from an initial 1.2 V to an end-point of about 1.45 V. The rate of rise increases markedly as the cell approaches full charge. The end-point voltage decreases slightly with increasing temperature.
Rob
OF78WD
Amateur moderator
.
→Arguing with a fool proves there are two
OF78WD
Amateur moderator
.
→Arguing with a fool proves there are two