Natural Wire Resistance

spartacus · Post by **spartacus** » Wed Oct 29, 2008 7:12 pm

Ok, let's say i buy a great expensive antenna and then connect it to my scanner using cheap copper wire. Would the different resistance in the cabling decrease my performance,
Just wondering, because i just stuck about 15 meters of bare wire outside the bathroom window and then used a VGA cable to get the signal where i wanted it to plug it into my scanner and hear it etc. etc.

Post by **vk6hgr** » Wed Oct 29, 2008 7:16 pm

spartacus wrote:Ok, let's say i buy a great expensive antenna and then connect it to my scanner using cheap copper wire. Would the different resistance in the cabling decrease my performance,

I'd say more an impedance problem than resistance, but much the muchness - shell out for the coax cable

spartacus · Post by **spartacus** » Thu Oct 30, 2008 4:44 pm

it's just for this week, i'm trying out some new positions to get the redbull planes. I've got enough shielded cable for my original position but as i'm southside, i've had to move everything from the south side to the north side of the house.
PS It works fine, a little bit of background crackle but pretty good.

Thanks anyway vk6hgr

Post by **robbage** » Thu Oct 30, 2008 4:54 pm

Is that 15 metres of bare wire the antenna and is it horizonal?

spartacus · Post by **spartacus** » Thu Oct 30, 2008 5:56 pm

robbage wrote:Is that 15 metres of bare wire the antenna and is it horizonal?

yep pretty much

WA Radio Scanner Users' Group

Natural Wire Resistance

Natural Wire Resistance

Re: Natural Wire Resistance