I have been given one of these, programmed codes in, got instruction manual from uniden site, but cant get anything, The only noise out of it is when i turn up the squelch! The L/O indicator is permanently on, cant seem to get rid of it, anyone familiar with this model or can help would be great
thanks
Uniden UBC60XLT - help please....
Moderator: Always RX
-
- Posts: 13
- Joined: Sun Jan 15, 2006 8:35 pm
- Location: Albany
- Contact:
You might be out of range to pick up any traffic, but with the L/O out function try press and hold it for about 5 secs this should cancel all the the current L/O channels. Other than that i would maybe try to pick up something you know is transmitting like a cb....and see if your scanner picks up that if it dosent well you know the problems lies deeper than a simple L/O
have any more probs im on msn a fair bit i may be able to help further....
have any more probs im on msn a fair bit i may be able to help further....
-
- Posts: 13
- Joined: Sun Jan 15, 2006 8:35 pm
- Location: Albany
- Contact:
No Luck
Hi Annt
No I tried what you suggested, and nothing, might have to take it to someone to check out, cant get the L/O on screen to go out tried all sorts, I should get a signal real good, got a friend over with her scanner programmed same code and hers works fine....but thanks for your help!
No I tried what you suggested, and nothing, might have to take it to someone to check out, cant get the L/O on screen to go out tried all sorts, I should get a signal real good, got a friend over with her scanner programmed same code and hers works fine....but thanks for your help!
Nina
-
- Posts: 13
- Joined: Sun Jan 15, 2006 8:35 pm
- Location: Albany
- Contact:
-
- Posts: 13
- Joined: Sun Jan 15, 2006 8:35 pm
- Location: Albany
- Contact: